Troubleshooting FPC Failures: Broken Traces, Cold Joints, and Delamination
Start with where the failure is: broken traces point to the bend area, cold joints to pads, finish and reflow, and blistering to moisture, lamination and storage.

Short answer: look at where the failure is first, and that tells you where to look next. A trace that breaks points to the bend area — its routing, its openings, and its stiffener. A cold joint points to the pads first, then the surface finish, then the reflow profile — in that order. Blistering or delamination points to material moisture first, then to lamination and storage. Use the troubleshooting table at the end: describe the failure with a photo, its location, and the batch, and that decides whether to change the design, adjust the process, or change the supplier.
Broken traces
A broken trace usually starts where the board bends. Check the routing through the bend area first: traces should run along the bend line, and the bend area should have no coverlay openings or vias. Then look at the stiffener — a stiffener that ends in the bend, or one that is missing where the board should stay still, lets the copper flex too sharply. A break at the fold line is a design problem; a break at a random spot is more often handling or a process fault.
Cold joints and lifted pads
A cold joint, or a pad that lifts after soldering, is a soldering problem until proven otherwise — so check in order. First the pads and the opening above them: is the pad clean, and is the coverlay opening the right size and in the right place? Then the surface finish: has the exposed metal oxidised, or is the finish wrong for the profile? Then the reflow profile: did the joint reach the temperature and the time the solder paste needs? Only after those three check out do you suspect the board itself.
Blistering and delamination
A blister on the coverlay, or layers coming apart, is usually moisture. Ask first whether the material was damp when it was laminated, and whether partly finished boards were stored somewhere humid. Then look at lamination: pressure and temperature that are too low leave weak bonds that part later. Boards that blister after soldering have almost always picked up moisture before the build — keep the material and the work-in-progress dry.
Troubleshooting table
When you report a failure, give the supplier four things: a photo of the failure, its exact location on the board, which batch the board came from, and what the board was doing when it failed. That is enough to trace it back to one of the three causes above.
Changing the design, the process, or the supplier
Change the design when the failure sits at the same place every time — a bend-area routing problem, a missing stiffener, or an opening over the wrong place. Adjust the process when the failure moves around between batches — a lamination window, a storage step, or a reflow profile. Change the supplier when the same failure keeps coming back at the same place even after the design and the process have been checked — a supplier that cannot repeat a good result is not going to fix itself.